CyberData 011433, Operation Manual, Page: 83 / 98

Operations Guide 931384A CyberData Corporation
Installing the Secure Access Control Keypad
Secure Access Control Keypad Setup
76
2.6 Command Interface
Some functions on the device can be activated using simple POST commands to the web interface.
The examples in
Table 2-23 use the free unix utility, wget commands . However, any program that
can send HTTP POST commands to the device should work.
2.6.1 Command Interface Post Commands
Note These commands require an authenticated session (a valid username and password to
work).
Device Action HTTP Post Command
a
Trigger relay (for configured delay) wget --user admin --password admin --auth-no-challenge --no-
check-certificate --quiet -O /dev/null "https://10.0.3.71/cgi-bin/
command.cgi" --post-data "test_relay=yes"
Place call to extension (example: extension 130) wget --user admin --password admin --auth-no-challenge --no-
check-certificate --quiet -O /dev/null "https://10.0.3.71/cgi-bin/
command.cgi" --post-data "call=130"
Terminate active call wget --user admin --password admin --auth-no-challenge --no-
check-certificate --quiet -O /dev/null "https://10.0.3.71/cgi-bin/
command.cgi" --post-data "terminate=yes"
Force reboot wget --user admin --password admin --auth-no-challenge --no-
check-certificate --quiet -O /dev/null "https://10.0.3.71/cgi-bin/
command.cgi" --post-data "reboot=yes"
Trigger the Door Sensor Test (Sensor Config page) wget --user admin --password admin --auth-no-challenge --no-
check-certificate --quiet -O /dev/null "https://10.0.3.71/cgi-bin/
sensor.cgi" --post-data "doortest=yes"
Trigger the Intrusion Sensor Test (Sensor Config page) wget --user admin --password admin --auth-no-challenge --no-
check-certificate --quiet -O /dev/null "https://10.0.3.71/cgi-bin/
sensor.cgi" --post-data "intrusiontest=yes"
Table 2-23. Command Interface Post Commands
a.Type and enter all of each http POST command on one line.