Page 2-12
Chapter 2
II. Using your PC-EPhone for the first time
Follow the steps in this section to start using your PC-EPhone for the first time.
(1)
Connecting the Battery to PC-EPhone
Install the Main Battery to your PC-EPhone as shown below.
Please place the battery in the slot leaving 4 ~ 5 mm space and push it firmly,
and be careful not to get the battery caught in the groove of PC-EPhone’s
battery slot. While inserting the battery, the battery slot can be damaged if
excessive force is used.
The Main Battery may be drained during the transportation from the factory to the
consumer; therefore you should connect AC power to the cradle and place your PC-
EPhone in it in order to charge the battery when using your PC-EPhone for the first time.
(2)
Check the following operations of your PC-EPhone
1. After connecting your PC-EPhone to a power source and pressing the Power button, the
CYBERBANK logo will be displayed for approximately 2 seconds, and then gives way to a
display that will help you calibrate the touch screen.
2. A target (+) will move in the order of
“center
→
→
→
→
upper left
→
→
→
→
lower left
→
→
→
→
lower right
→
→
→
→
upper right”
, to different locations on your screen. Since calibrating the touch screen has
a direct affect on the recognition ability of your touch screen, be sure to accurately tap the
center of the target (+) with your stylus. For more information, see the
Setting PC-
EPhone Preferences section in Chapter 3
.
(3)
Setting System Preferences
Before using your PC-EPhone, you should customize it to your needs by setting basic
system preferences in the
Control Panel
. You may also set preferences during use. On
Summary of Contents for PC-EPhone
Page 1: ...User s Manual 2001 2...
Page 2: ......
