CYBELEC CybTouch 8 P, User Manual

Page: 37 / 44

31/38
CybTouch 8 P User Manual
S
ep
.
2019
V2.1
e
rror and
w
arninG
M
eSSaGeS
Following is a list of warning and error
messages which may be displayed on the
interactive message line of the CybTouch.
There are two types of messages:
• Warning Messages , which are displayed
on a green background. They are
information or instructions that will
disappear automatically.
• Error Messages (machine or NC
errors), which are displayed on a red
background. They inform the user of an
error occurring on the machine or NC,
and sometimes require intervention by
the end user or a technician.
w
arninG
M
eSSaGeS
M
SG
n
r
. M
eSSaGe
d
eScripTion
W02 Ignore This message appears when the desired action makes no sense,
like for example clearing the indexation when the indexation was
not made.
W03 Code accepted This message is displayed when the correct password has been
entered.
W04 Please press 3 seconds This message reminds the operator to keep the start pump
button
pressed for 3 seconds.
W05 The pump is on This message appears after the pump starting cycle has been
correctly executed.
W06 The pump is off This message indicates that the pump has been stopped.
W07 Machine not indexed Before the machine is indexed, the NC doesn’t know where the
axes are. In manual page, movements are authorized but the
electronic stroke limits are not activated. Operator is responsible
for stopping axis movement before mechanical limit is reached.
W08 Touch OK to continue Indicates that a validation is required to continue.
W10 Cycle in progress While this message is displayed, the machine cycle is in progress
and the screen is locked, except for the Stop button.
W11 Machine is indexed Indicates the indexation cycle was successful.
W12 Identification OK In the Axis Wizard, indicates the identification cycle was
successful.
W15 Input in programming mode ! The “Next Seq+Start” or the “Pressure reached” input is
activated while NC is in programming mode. If the message
persists, check the machine status.
W16 Eco mode This message appears when the Eco mode starts, after the timer
defined in the machine parameters is over.
When reporting error messages, please ALWAYS indicate the error number at
the end of the line. This number also refers to the first column in the section
below.
Interactive
message line
Message number