CYBELEC CybTouch 8 G, User Manual

Page: 38 / 40

32/34
CybTouch 8 G – User Manual
A
ug
.
2016
V3.1
M
SG
n
r
. M
eSSaGe
d
eScripTion
E65 X axis is not configured RTS is configured in machine parameters, while X axis is not
configured. X axis must be configured for the RTS function to be
available.
E66 Fw Axes Error 33 [Maximum
voltage time exceeded (10V)] Same message as E58 .
E67 Fw Axes Error 39 [Speed
tracking error] Same message as E58 .
E68 Fw Axes Error 316 [MinPosition
or MaxPosition outside limit ! ] The axis management detects a set-point outside the limits.
Check all the axis parameters. If the error occurs frequently,
make a trace and send it to Cybelec.
E69 Parking not allowed with RTS Parking and RTS functions cannot be used at the same time.
Deactivate one or the other.
E70 Blade gap out of limit When a movement is attempted, the blade gap is out is out of
machine limits. Check the Material page.
E71 File access error There was an error when trying to access a file while
programming an option. Make sure that the code was entered
properly. If it is not working try and restart the NC. If the problem
persists, contact Cybelec.
E72 Unknown error An unknown error occured while trying to program an option.
Contact Cybelec.
E73 Thin sheet support X safety
(max x mm) A safety zone is defined while using the thin sheet support. The
thin sheet support cannot be used while X is programmed in that
zone.
E74 Bad serial number The code entered for the new option you try to install is not
correct.
E75 Parking on time out The timer defined in the machine parameters is expired. Check
the back gauge’s parking movements.
E76 Parking off time out Same message as E75 .
E77 Thin sheet support thickness
too high (max x mm) Thickness of the sheet is bigger than the limit defined in the
machine parameters.
E78 Beam Calibration probably not
OK When trying to make a cut, the CybTouch detected that the
beam’s calibration was not OK. If the problem persists, call a
technician to check the machine parameters and check the
values.
E79 “TDC max” input is not active During the Cutting Length Wizard, the beam has not reached
TDC max.
E80 Movement locked This message is displayed when the machine is equipped with
2 blade gaps and the operator tries to select one of them in the
machine parameters without unlocking the padlock first.
E81 Sheet support thickness too
high (max x mm) Thickness of the sheet is bigger than the limit defined in the
machine parameters.
E82 Anti twist X safety (min x mm) This message is displayed when trying to use the anti-twist
function with a back gauge position (X axis) inferior to the
minimum allowed defined in the machine parameters.
E83 Anti twist: Material thickness
too large Thickness of the sheet is bigger than the limit defined in the
machine parameters.
E84 Sheet support input time-out This message appears when an up or down order is given to
the sheet support and the corresponding input has not changed
state before the timer defined in the machine parameters ran
out.