CYBELEC CybTouch 8 G, User Manual

Page: 37 / 40

31/34
CybTouch 8 G – User Manual
A
ug
.
2016
V3.1
M
SG
n
r
. M
eSSaGe
d
eScripTion
E43 Configuration error Input/output incorrectly configured in machine parameters, the
error input/output page is displayed. Check for unauthorized
doubled output or inputs.
This message can also be displayed if the chosen configuration
requires more icons on the first page than there room available.
E44 “External stop” input is active External stop may be caused by safety devices, emergency
buttons, rear protection guards, etc. See machine instructions.
E45 “Blade gap” analog input not
configured While configuring (setting up) the CybTouch, dedicated input or
output were not configured but are requested to run properly.
E46 “Pressure” analog output not
configured Same message as E45 , but for the pressure.
E47 Error calculating cutting angle These messages appear if entering improper values during the
Cutting Length Wizard. Start the wizard again, measure and enter
values with care.
E48 Error calculating cutting length
E49 Max pressure moving to TDC While the beam was returning to TDC, the CybTouch provided
maximum pressure output, perhaps due to a friction point or a
setting point. This case should not occur.
E50 Value out of limit This message is displayed when the value the operator is trying
to be program is bigger than the maximum authorized value.
E51 Error[ ][ ][ ][ ]... Internal management error. Write the error’s codes down and
the software’s number (see
Information, page 12 ) and call
Cybelec.
E52 “Blade gap2” analog input not
configured Same message as E45 , but for the second blade gap.
E53 “TDC Max” digital input not
configured Same message as E45 , but for TDC max.
E54 “BDC Min” digital input not
configured Same message as E45 , but for BDC min.
E55 Identification Error 1 (No
motion detected) No motion detected. Should not happen if you started the Wizard
from the beginning. If the error remains, check limit switches,
drive, wiring, etc.
E56 Identification Error 2 (Not
enough oscillations) Not enough oscillations Increase the identification time. See
machine parameters manual.
E57 Identification Error 3
(Amplitude of the oscillation) Oscillation amplitude. Increase the identification voltage. See
machine parameters manual.
E58 Fw Axes Error 32 [Trajectory
tracking error] This is a regulator error. The axis could not follow its trajectory.
Reset the error. If problem persists, call a technician.
E59 Fw Axes Error 311 [MaxSpeed
too high !] Max speed or encoder resolution too high.
E60 Fw Axes Error 312 [MaxSpeed
too small !] Max speed or encoder resolution too low.
E61 Fw Axes Error 313
[Acceleration too small or
MaxSpeed too high !] Acceleration too low (mm/s
2
) or max speed too high. This needs
to be corrected. Please note that acceleration is not a ramp
distance.
E62 Fw Axes Error 314
[Acceleration too high or
MaxSpeed too small !] Acceleration too high (mm/s
2
) or max speed too low. This needs
to be corrected.
E63 “Cutting length” analog input
not configured Same message as E45 , but for the cutting length.
E64 “Cutting length” encoder not
configured Same message as E45 , but for the cutting length encoder.