43
11. Vulcan Installation
11.4.4 Installation instructions for the Commercial & Industrial Line
1. Put the two band holders through the fixing holes at the bottom of
the electronic device. Now place the device onto the pipe. Use the
band holders to latch the device to the pipe.
2. Plug one of the impulse bands into the bottom impulse band in-jack
and latch it to the pipe using another band holder.
3. Wind the impulse bands around the pipe producing a coil. Make sure
you wind the band tightly to the pipe and place the windings close
to each other.
4. Latch the end of the band to the pipe using another band holder.
Now plug another impulse band into the in-jack on the opposite side
and repeat the procedure.
5. Plug another impulse band into the next impulse band in-jack and,
according to the device type, repeat steps 2 - 4 until all impulse
bands are in use. All impulse bands must be wound tightly around
the pipe and fastened with band holders.
6. First plug the connector into the upper right in-jack of the device and
then connect the power supply unit with an electrical outlet.
7. Now adjust your Vulcan on the side sensors according to your pipe
diameter to optimally treat your water.
See section 12 for program setting.
The CWT Impulse Detector
Show what is going on, if you have a impulse detector with you.
The detector is a good tool when you show Vulcan to new customers.
With the audio perception, the client gains a better understanding of the
impulse treatment.
When you hold the detector close to the impulse cables you can check
the functionality of Vulcan.
Im
pu
lse
Detector
Impulse
Detector
