P/N IM-C35KD Rev. C
2014 Commercial Wireless Systems International, LLC.
32
When a repeater, annunciator or wireless relay is edited, the serial number, device type, description
and point ID are shown. The description is the only editable field for these units. Zone and alarm
priority information do not apply to a repeater, annunciator or wireless relay. A sample repeater edit
screen is shown below. Note: The first time a repeater is edited, the title on this screen will read New
Repeater Setup. For annunciator or wireless relay screens substitute the appropriate unit instead of
repeater in the following examples. A wireless relay will count as a device registered.
The same field editing rules apply here as described in section 4.2.3. Move the cursor to the desired
field and press ENTER. When done editing press ENTER again to exit edit mode. When a field has
been modified, the word save will appear above the #4 soft key. Save after you have made all of the
desired changes as pressing the save button will back you out to the Select Device to be Edited
screen. If you press the BACK key without saving a save confirmation screen will appear. Make the
appropriate selection when prompted.
4.4.2 Deleting a Device, annunciator or repeater
To delete a device, annunciator or repeater from the system:
1. Locate the Device(s), Annunciator(s) and/or Repeater(s) you want to delete and remove all
power from it.
2. Allow the powered down units in step 1 to show a test failure trouble.
3. Reset the CP-3500D and access the device edit list through the device edit menu choice.
4. Use the UP/DOWN keys to select the device(s) and/or repeater(s) to be deleted and press
the delete soft key.
Warning: The CP-3500D will no longer accept alarms or troubles from deleted devices or
repeaters. To get a deleted device, annunciator or repeater to report to the CP-3500D again
you must enroll it. You must remove all power from a device, annunciator or repeater and
allow it to show a test failure trouble on the CP-3500D before deleting it. Failure to remove
power and allow the device, annunciator or repeater to show a test failure trouble prior to
deleting may cause an unknown device trouble on the CP-3500D. Refer to the section on
unknown and ignored devices for more information.
When a repeater is deleted, you will be
prompted with a warning telling you that the repeater will be permanently disabled until its power is
removed and reapplied. Answer yes to continue with deleting the repeater. The repeater will be sent a
E d i t R e p e a t e r
ALPHA Number Symbol
S e r i a l # : 0 3 a 4 9 2
De v ic e T y p e : Re p e a t e r
De s c r i p t i o n :
P o i n t I D
: 0 0 0 9
T o t a l R e p e a t e r s R e g is t e r e d : 0 0 0 1
