10
Understanding the remote control features
•
The adjustable bed uses RF (radio frequency) remote control system.
•
The buttons are backlit when pressed to aid in the visibility of the remote in low light environments.
•
It is not necessary to face the receiver when operating the remote control. Remote signal is best transmitted
within 9 feet (3 meters) of the bed.
NOTE:
The bed may show minor intermittent performance because of typical radio frequency interference. This
is normal in the operation of the bed, not a defect.
Remote Control Guide
Synchronizing two beds for tandem operation
To operate two adjustable beds together, you must pair both remote controls to both beds.
Make sure both beds A and B are plugged into a working and
grounded electrical outlet.
Pair Remote A to Bed A. Place Remote A over the control box
of Bed A until you hear a beep.
Pair Remote A to Bed B. Place Remote A over the control box
of Bed B until you hear a beep.
Repeat steps 2 and 3 using remote B to pair it to both beds.
When complete, either remote A or B can now control both
bed in tandem.
1
2
3
4
Rest (3)
Press this preset button to adjust the head and foot sections of the bed into a comfortable rest position.
TV/PC (4)
Press this preset button to raise the head and foot sections of the bed into an ideal position for watching
TV, reading a book, or using a laptop or smart device.
Anti Snore (9)
Press this preset button to raise the head section and allow easier air intake which can help reduce
snoring.
Flat (10)
Press and hold this button for two (2) seconds to return the bed to a flat position.
Zero Gravity (6)
Press this preset button to elevate the legs slightly higher than the chest, in effect, allowing the blood to
flow back to the heard to help reduce stress and fatigue.
