HB1030E Manual Revision: 7 Page 9 of 28
Operation
Preliminary Unpacking Instructions and Dealer Inspection
Maintenance locks must be engaged prior to inspecting or servicing the unit when the platform is extended.
Inspect machine for any possible damage during shipment; perform a pre-delivery inspection. Reset emergency
stop switches, if necessary.
Transport and Storage Information
Preparation for Transport
Lower the work platform to the down position. Bring the platform extension into the retracted position and locked
in place. Remove any loose items from machine.
The machine can be pushed by releasing the parking brake at the rear of the machine. Towing is not
recommended.
A forklift pocket and tie down/lift points are provided for loading and unloading and for securing the machine on a
trailer or truck bed for transport between places of use. A forklift may also be used from the side of the machine.
Do not use a forklift from the back.
WARNING
DO NOT OVER-TIGHTEN LOAD BINDERS
WHEN SECURING LOAD FOR TRANSPORT
Securing to truck or trailer for transport
Turn key switch to off position
Check entire machine for loose or unsecured items.
Storage
After periods of storage, exposure to extremes of ambient conditions-heat,
cold, moisture, dust etc. inspect the machine. Refer to the Pre-Delivery/
Frequent Inspection Checklist.
CM: X: 82 cm, Y: 24 cm
Figure 9: Center of Mass
Forklift
Figure 8: Forklift Pocket,
Front Tie Down/Lift Points
Tie Down/
Lift Points
Tie Down/
Lift Points
Figure 7: Back Tie Down/Lift Points
HB1030E Manual Revision: 7 Page 10 of 28
Controls
Lower Controls
Figure 10: Lower Controls
Upper Controls
Figure 11: Upper Controls
Item
Control Description
1 Key
Enables
machine
controls
2
Hour Meter/
Battery
Gauge
Indicates total elapsed time
machine has been operated.
Indicates charge left in
battery.
3 Tilt
Alarm
Sounds audible alarm when
machine tilted. If elevated,
platform should be lowered
immediately.
4
Descent
Alarm
Sounds audible alarm when
scissors is lowering.
5
Lift/Lower
Switch
Controls lifting and lowering
of platform from the base.
6
Overload
Indicator
When the rated load is
exceeded, this light flashes,
an alarm sounds, and
movement other than
emergency descent is
prevented until the overload
is removed.
7
Control
Location
Selector
Rotate knob to select platform
or ground controls.
8
Emergency
Stop
Push to stop all functions in
emergency. To reset, pull
knob out.
9
Diagnostic
LED
Refer to flash codes in
Troubleshooting section.
Item Control
Description
1
Lift/Lower Enable Button Must be pressed to lift and lower platform from platform.
2
Emergency Stop
Push to stop all functions in emergency. To reset, pull knob out.
3
Drive Enable Switch
Must be depressed to drive.
4
Thumb Steering Switch
Press switch with thumb to the left to turn wheels left, right to turn wheels right.
5
Joystick Controls
speed.
6
Horn
Press the horn button for an audible warning.
7
Tilt Indicator
Lights when permissible inclination is exceeded.
8
Overload Indicator
When the rated load is exceeded, this light flashes, an alarm sounds, and
movement other than emergency descent is prevented until the overload is
removed.
9
Lift/Lower Switch
Controls lifting and lowering of platform from the base.