Custom Audio Electronics KUBE 120, User Manual

Page: 82 / 92

Mass Storage / FTP Server
It is possible to add the new logo directly into the folder “PICTURES” on the Flash Drive of the device.
You can enter the Flash Drive by iles sharing from Mass Storage or by iles sharing from FTP Server connection (see par.
11.1).
In both cases, the relative parameter should be enabled during the coniguration process (see chapter 5).
After adding the logo, open the coniguration ile “PictList.ini” and add a new line with a number associated to the logo
(to be used with device’s commands), a letter for the memory unit and the logo ile name, as indicated in the instructions
written inside the “PictList.ini” ile.
To delete a logos stored in the device, proceed as follows:
1.
delete the selected logo from the “Pictures” folder on Flash Disk or SD/MMC card;
2.
in the coniguration ile “PictList.ini”, delete the line related to the erased logo.
The logos stored into a unit memory and converted by the device, can be printed by using the number associated to the
logo during the conversion step.
The correspondence between ile-name and logo-number is warrant by the coniguration ile “PIctList.ini” and it is veriiable
with the logo test.
ATTENTION: The coniguration ile “PictList.ini” on the device’s Flash Disk, has to be modiied even if the new added
logo is stored on SD/MMC.
NOTE: To know the IP address of the device, print the Set-up report of the device (see chapter 5) or use “Locator”.
Type in the address bar “ftp://” followed by the IP address of the device.
82