The following igures shows the device setup reports. The shown values for parameters are sample values; for a detailed
description of the device operating parameters see the following paragraphs.
DEVICE NAME AND
FIRMWARE MODULES
RELEASE
PRINTING HEAD
STATUS
PRINTER SETTINGS
1 •••••••• 640
----------------------------------------------------------------------------
PRINTHEAD WORKING GOOD!
PRINTER TYPE ............................... <device model>
RFID Module .................................... <RFID>
RFID Module Release ...................... <RFID rel.>
PRINTING HEAD TYPE ................... <head model>
INTERFACE ..................................... USB
PROGRAM MEMORY TEST............ OK
DYNAMIC RAM TEST...................... OK
CUTTER TEST................................. OK
HEAD VOLTAGE
[V] = 24.17
HEAD TEMPERATURE
[°C] = 24
POWER ON COUNTER
= 10
PAPER PRINTED
[cm] = 160
CUT COUNTER
= 3
Printer Emulation .......................... :
CUSTOM POS
RS232 Baud Rate ........................ :
115200 bps
RS232 Data Length ...................... :
8 bits/chr
RS232 Parity ................................ :
None
RS232 Handshaking .................... :
Hardware
Print Mode .................................... :
Normal
Busy Condition ............................. :
RxFull
Autofeed ....................................... :
CR
Disabled
Chars / Inch .................................. :
A=15 B=20 cpi
Font Type...................................... :
International
Speed / Quality............................. :
High Speed
Print Width .................................... :
80 mm
Paper End Management .............. :
Print All
AUX RS232 Baud Rate ................ :
115200 bps
Paper Threshold ........................... :
40%
Notch/B.Mark Pos. F1 ................. :
Bottom
Notch/B.Mark Pos. F2 ................. :
Bottom
PaperEnd Buffer Clear ................. :
Disabled
PrintHead Test PowerOn .............. :
Disabled
USB Address Number .................. :
0
USB Class .................................... :
Printer
Ejector Speed ............................... :
75%
Print Density................................. :
0%
[ LF ]
enter Printer Setup
[ FF ]
enter Ethernet Setup
<device name>
S/N: <number>
SCODE.
<
code
>
- rel 1.00
FCODE.
<
code
>
- rel 1.00
DCODE.
<
code
>
- rel 1.00
DEVICE
STATUS
PARAMETERS
FOR DEVICE
CONFIGURATION
KEYS FUNCTIONS
ETH. SPEED = 100Mb/s Half-Duplex MDIX
DHCP Client ................................. :
Disabled
IP Address .................................... :
192.168. 0. 1
Subnet Mask ................................ :
255.255.255. 0
Default Gateway........................... :
192.168. 0. 5
MAC Address ............................... :
00-0E-E2-02-00-00
[ LF ]
enter Ethernet Setup
[ FF ]
skip Setup
ETHERNET
PARAMETERS
KEYS FUNCTIONS
81
Summary of Contents for KPM862
