CUSHCRAFT R9, Assembly And Installation Instructions Manual

Page: 6 / 16

11
4 PLACES
941
4 PLACES
5
#3- ASSEMBLE PLASTIC
SPACERS TO RADIAL RINGS
09 010009 SS Machine # 8-32 x 5/8" 12
Screw (1.6 cm)
11 010011 SS HEX NUT 8-32 15
941 011941 SS Split Lock # 8 15
Washer
231 010231 SS Machine 8-32 x 1-3/4" 3
Screw (4.45 cm)
657 194657 Aluminum 6
L Bracket
940 360940 Aluminum # 8 12
Flat Washer
BB R8BB R8 Tube 1-1/4" x 72" 1
(3.2 x 182.9 cm)
BC R8BC R8 Tube 1-1/8" x 72" 1
(2.9 x 182.9 cm)
5072 205072 4-Hole
Plastic Insulator
5096 205096 3-Hole
5097 205097 2-Hole
KEY P/N DISPLAY DESC SIZE QTY
657
2 PLACES
R9
941
11
231
11
4 PLACES
940
4 PLACES
5072
09
4 PLACES
BB BB
231
231
941
11
657
2 PLACES
657
2 PLACES
5096
5097
BC
BC
11
4 PLACES
940
4 PLACES
940
4 PLACES
09
4 PLACES
09
4 PLACES
941
4 PLACES
941
4 PLACES
941
11
Place the aluminum L-brackets (657) on tube (BB) and secure them
with hardware (231,941&11). Repeat this as well on tube (BC) as
shown on Fig. "F". Slide the 4-hole insulator (5072) on tube (BB)
and secure it with applicable hardware ( 09, 940,941 & 11). Repeat
the same with two and three hole insulators (5096 & 5097) on
tube (BC) according to Fig. "F".
NOTE: Make sure that the tubes are oriented with the slotted ends
on the top when you start assembling the hardware onto them.
FIGURE F
1
1
1
Plastic Insulator
Plastic Insulator