CUSHCRAFT R9, Assembly And Installation Instructions Manual

Page: 5 / 16

4
32 902832 SS RADIAL 49" 7
(124.5 cm)
BRACKET
87 014387 SS LOCK #8-32
NUT
326 290326 WARNING 7
LABEL
MN MN8 MATCHING 1
NETWORK
#2- ATTACH MATCHING
NETWORK AND RADIALS
KEY P/N DISPLAY DESC SIZE QTY
FIGURE E
190160 160
220 010220 SS HEX NUT #10-24 1
233 010233 SS SPLIT #10 1
LOCK WASHER
941 011941 SS SPLIT #8 3
LOCK WASHER
11 010011 SS HEX NUT #8-32 3
11 11
MN9
220
32
32
32
32
326
11
32
326
326
326
326
160
120
87
941
941
941
233
1
1
1
MN8
Slide upper matching network bracket (160) onto base section
(BA). Place it tight against the fiberglass insulator. Insert one
2" screw (120) into bracket (160) and attach nut (87) as
shown in Figure E. Slide Matching Network screws into holes
on upper matching network bracket (160). Position bottom MN
bracket over captive screw in base section (BA) and secure
with #10 nut (220) and a #10 lock washer (233).
Secure MN to upper MN bracket (160) with two nuts (11)
and lock washer (941). Tighten screw in upper MN bracket
(160).
The radial rods may be inserted into the base section at any
time in the assembly process.
One at a time, place the stainless radial rods (32) into the
slots in the radial rings. Tighten the corresponding ring screws
as you work your way around the rings. The radial rings do
not have to touch each other to secure the radial rods properly.
Do not overtighten the screws. When all rods are secure,
tighten all hardware on the base section. Attach jumper strap
(428) to MN screw with nut (11) and lock washer (941).
Attach warning labels (326) as shown.
R9
120 010120 SS MACHINE # 8-32 x 2"
SCREW (5.1 cm)
428