p. 5 of 11
CABS/BLADES/ SPREADERS/ACCESSORIES
3. FRONT COWL (cont’d.)
3.4
For all models,
place the cowl assembly onto the tractor with the flap of
bulb rubber extended inward towards the passenger’s compartment as shown
in fig. 3.4.
4. SIDE FRAMES
4.1 Remove doors from side frames (for easier handling) by unlatching and slid-
ing up and off the hinge pins..
4.2 Install left and right side frames to vehicle as shown in fig. 4.2. The bottom
of the side frame is to be on top of the tractor floorboard, but under the rub-
ber mat and under the bottom, bent flange of the front cowl assembly. Fasten
to front cowl assembly and rear legs using 5/16 x 3/4” long button head
screws, steel washers, and nylon washers. Push the side frame back and in-
stall a new, longer floorboard bolt (3/8 x 1 1/2” long carriage bolt), washer,
and locknut. The bolt is to pass through the bottom of the side frame and the
floorboard.
5. FRONT WINDSHIELD SUPPORT
5.1 Install the front windshield support to the side frames with the bent flange
down. Install only the bottom two 5/16 x 3/4” long button head screws, steel
washers, nylon washers, and locknuts. (see fig. 5.1) (Note: the top holes will
get fasteners once the roof is installed.)
6. WINDSHIELD
6.1 With assistance, install the windshield to the windshield support (see fig.
6.1). Use four 5/16 x 1 3/4” long flat head screws and 3/4” thick plastic
spacer blocks (placed between the plastic hinge and the windshield support
as shown in fig. 6.1.1). Do not tighten.
6.2 To install windshield bottom latches into the cowl brackets, open windshield
slightly. Grasp and squeeze the spring-loaded tabs and cradle latches into
cowl brackets, aligning tab bosses with their respective mounting holes.
3/4” thick spacer
Fig. 6.1.1 Spacer Block
Fig. 6.1 Install Windshield
Fig. 5.1 Windshield Support
only these two holes
Fig. 4.2
Side-
frame
Fig. 3.4 front cowl
installed (20 series shown)
bulb rubber inwards