p. 8 of 11
CABS/BLADES/ SPREADERS/ACCESSORIES
11. REAR CURTAIN (soft sided only)
11.1 Install rear curtain by snapping to the inside back vertical edge of the roof.
(see fig. 11.1)
11.2 (NOTE: adhesive backed velcro should be applied to a clean, dry surface at
room temperature.) Apply self adhesive hook velcro, as needed, along the
rear legs and rear panel. Adhere rear curtain to newly applied velcro strips.
12. FINISHING TOUCHES
12.1 Install wiper motor per instructions included with the wiper kit.
12.2 Install 5/16” plastic nut covers on all interior 5/16” locknuts.
12.3
For the 00 Series and 10 Series models
(ref.: 4500, 4600, 4700, 4510, 4610, and 4710)
:
Install vinyl front fillers by applying self adhesive hook velcro, as needed,
along the hood and front legs as shown in figure 12.3. (NOTE: adhesive
backed velcro should be applied to a clean, dry surface at room temperature.)
(NOTE: left, driver’s side shown, repeat for opposite side.) Install front vinyl
fillers to newly applied velcro strips.
12.4
For the 20 Series models
(ref.: 4120, 4320, 4520, and 4720)
:
Cut the vinyl front fillers as shown in fig. 12.4. Cut along the white
lines shown on the photo being sure to cut on the appropriate side
of the loop velcro. The photo shows the loop velcro side up. The
long cut to be made should follow along the edge of the 5/8” wide
loop velcro so the loop velcro remains fully intact on the small
piece of vinyl that is labeled “keep for 20 Series”. The shorter cut
to be made is approximately parallel to the bottom edge as shown
(finished product is shown in fig. 12.4.1). Apply self adhesive
hook velcro, as needed, along the hood and front legs. (NOTE:
adhesive backed velcro should be applied to a clean, dry surface
at room temperature.) Install the newly cut (saved) portion of the
front filler to the newly applied hook velcro on the vehicle (not
shown).
12.5 Install the rear filler as shown in fig. 12.5 in the same manner
as the front fillers. If your tractor is equipped with a backhoe,
cut the filler around the hydraulic lines using snips.
Fig. 11.1 Rear Curtain
Vinyl filler
Fig. 12.3
00 Series and 10 Series front filler installed
Hood
Front leg
Vinyl filler
Fig. 12.5
Rear filler
keep for 20 Series
discard for 20 Series
Fig. 12.4
20 Series front filler prep.
cut
lines
Fig. 12.4.1
20 Series front fillers
shown after being cut out
of larger 00 Series and 10
Series front fillers
