p. 7 of 11
CABS/BLADES/ SPREADERS/ACCESSORIES
8. REAR WINDOW (continued)
8.2 Install rear window using same procedure as windshield. Once aligned and
tightened, open window and install gas springs to ball studs provided. Re-
lease latches from latch mounts and open window all the way in order to
snap the gas springs onto the ball studs. (see figures 8.2, 8.2.1, & 8.2.2).
Note: rear window has holes for optional wiper.
Note: rear window can be opened for ventilation, or latches can be com-
pletely released to access rear attachments.
9. FLOORBOARD (drill hole)
9.1 Line up the hole in the floorboard with the hole in the bottom, bent flange of
the front leg. Using these holes as a guide, drill thru the tractor floorboard
with a 3/8” drill bit as shown in fig. 9.1.
9.2 In this newly drilled hole, install a 5/16 x 3/4” long button head screw, steel
washers, and locknut.
9.2 Re-install the plastic pins to secure the floor mat.
10. DOORS
10.1 Install doors onto hinges. (see fig. 10.1) Work the doors back and forth
until
the hinges are completely seated. (NOTE: the hinges, inside latch, and
striker bolt can also be adjusted for proper engagement.)
10.2 On hard sided cabs install the gas springs to the frames and doors with
the small piston end towards the door. (See fig. 10.2) Press the button on the
compression fastener to lock the gas spring to the ball stud.
10.3 On soft sided cabs install the cable stops and hardware provided similar to
how the gas springs are installed (see 10.2).
WARNING Do not attempt to
install gas springs on soft sided doors as this will damage to the doors!
10.4 Tighten all remaining bolts.
Rear Window
Fig. 8.2.2 Install Gas Springs
Gas Spring
Fig. 8.2 Install Rear Window
3/4” spacer
Fig. 8.2.1 Release latches
latches
Fig. 10.1 Install Doors
Fig. 9.1 Line up holes
drill here
Fig. 10.2 Gas
spring installation