KUBOTA B SERIES PHASE II HARD & SOFT SIDE CABS
7. ROLL BAR BRACKET & REAR LEG (cont’d.)
7.2 Place the left and right rear legs, or rear panel assembly, on the
tractor. Install to side frames with 3/4” long allen head bolts in
the middle holes. Install the light brackets to the bottom holes
with 3/4” long allen head bolts as well. NOTE: the top holes
will receive hardware during roof installation.
7.3 On the following nine models: 1700, 2100, 2400, 2410, 7300,
7500, 7410, 7510, and 7610, bolt rear legs to fender contours
with 3/4” long allen head screws and plastic washers as shown
in Fig. 13. These holes are
not
used on any other models.
DO NOT DRILL FENDERS ON ANY TRACTOR!
8. WINDSHIELD
8.1 Install 3/4” thick spacers from hardware box onto windshield
hinges and insert flat head bolts. See Fig. 14. Have an assistant
help lift the windshield in to place and install flat washers and
locknuts. Attach windshield latches to windshield latch receiv-
ers on the cowl by squeezing tabs to retract spring loaded pins.
See Fig. 15. Lift up on bottom of windshield while closing
latches. Check alignment of windshield with side frames and
tighten hinge hardware.
NOTE: Hinges are plastic com-
ponents. Do not over tighten hardware. Torque to 7
foot/pounds max.
9. ROOF
9.1 With assistance, place the roof on top of the cab. Fasten roof to
back of unitized side frames with two 1” long allen head
screws through the corners of the rear roof flange and rear legs
and into the threaded inserts in the side frame. Snug these two
bolts up. NOTE: the top of the rear legs are to be in between
the rear flange of the roof and the back of the side frames.
Ref.: Fig. 16 shows a hard rear panel assembly being installed.
Install 1” long allen head bolts into front two corner holes in
roof and bolt to unitized frame tabs with locknuts. Reminder:
use plastic washers under the heads of all exterior fasteners.
9.2 Complete the roof installation using 3/4” long allen head bolts
and plastic washers in the remaining roof holes. NOTE: on soft
sided cabs, the three middle slots on the rear flange of the roof
do get used.
CABS/BLADES/ SPREADERS/ACCESSORIES
p. 5 of 10
Fig. 12
Fig. 13
Fig. 14
Fig. 15
Fig. 16
outside edge
of roll bar
head of carriage bolt
light bracket
spacer
latch receiver