KUBOTA B SERIES PHASE II HARD & SOFT SIDE CABS
10. FINISHING TOUCHES
10.1 Have an assistant help lift up the back of the cab to get the roof
level and tighten the roll bar bracket bolts.
10.2 Tighten the remaining bolts aligning the edges of the panels
with the edges of the side frames as appropriate. Install plastic
nut covers on all exposed locknuts on the interior of the cab.
10.3 On the following three models: 2710, 2910, and 7800, use the
slots in the back of the floorboard extensions (Fig. 17; location
A) as a guide to drill an 11/32” dia. hole in the tractor floor-
board. Install a 1” long carriage bolt in the slot at location A
and tighten. NOTE: the slot next to location A is not used on
these three models.
On the following nine models: 1700,
2100, 2400, 2410, 7300, 7500, 7410, 7510, and 7610,
install a
1” long carriage bolt in the slot at location B and tighten. See
Fig. 18. NOTE: location B was previously drilled out in VEHI-
CLE PREP step 1.3.
10.4 If tractor has a loader, install the pocket type vinyl filler to the
inside of the loader valve cutout with velcro as shown in Fig.
19. See page 9 for the pocket type vinyl filler versus the flat
vinyl filler.
NOTE: adhesive backed velcro should be ap-
plied to a clean, dry surface at room temperature.
If there is
not a loader, install the flat vinyl filler over the cutout in the
cowl by attaching with velcro to the inside of the cowl.
10.5 If installing a soft side rear curtain, snap the curtain to the roof
in four places and to the bottom of the rear legs two places per
side. Apply the supplied hook velcro to the long, vertical,
inside edges of the rear legs, to the inside fender contours, and
to the top of the seat belt support bar as needed. See Fig. 20.
10.6 If installing a hard rear panel, velcro the black rubber, rear
filler to the lower rear legs as shown in Fig. 23 by applying
hook velcro to the vehicle as necessary.
CABS/BLADES/ SPREADERS/ACCESSORIES
location A
p. 6 of 10
Fig. 17
Fig. 18
Fig. 20
location B
Fig. 21
left filler
Fig. 19
filler
Fig. 22
Fig. 23
right filler
rear filler
velcro
