![background image](http://html.mh-extra.com/html/curtis/1jd2520as/1jd2520as_installation-instructions-manual_2700163009.webp)
9. WINDSHIELD SUPPORT
9.1
Install the windshield support to the side frames
with the bent flange down. Install only the bottom two
5/16-18 x 3/4” long button head bolts, two steel washers,
and two plastic washers per fig. 9.1. Two steel washers
and two locknuts to be on the inside surface. Note: the
top holes will get fasteners once the roof is installed.
p. 9 of 16
8. FRONT LEGS
For all models, leave the black Heyco plugs in place un-
less installing an optional heater.
8.1 For model 2320 only
, install the front leg by sliding
in from the outside as shown in figures 8.1, 8.1.1, and
8.1.2. The top flange of the front leg goes behind the
cowl against the side frame tubing. Caution: handle the
front leg with care to avoid damaging the factory in-
stalled foam. Reposition the foam after assembly if nec-
essary using a flat bladed screwdriver. Repeat all of step
8.1 for opposite side of vehicle.
8.2 For models 2520/2720 only
, install the front leg so
that the top flange of the front leg is underneath the cowl
as shown in fig. 8.1.2. Per fig. 8.1.3, the bent tab on the
front leg bottom piece must be inside the front leg as
shown. Reposition the foam after assembly if necessary
using a flat bladed screwdriver. Repeat for opposite side.
8.3 For all models
, attach the front leg to the cowl and
side frame using three 5/16-18 x 3/4” long button head
bolts, three steel washers, and three plastic washers per
side on the outside surface. On the inside surface, use
one steel washer and one locknut per side. Ref.: two bolts
per side thread into factory installed threaded inserts in
the side frame tubing. Repeat for opposite side.
8.4 For models 2520/2720 only
, install one more bolt
to the front of the front leg to attach it to the front leg
bottom piece as shown in fig. 8.1.3. Use one 5/16-18 x
3/4” long button head bolt, one steel washer, and one
plastic washer on the outside surface and one steel wash-
er and one locknut on the inside surface. Repeat for op-
posite side.
Fig. 8.1 Right Front Leg (model 2320 shown)
line up contours
and slide together
Fig. 8.1.1 Right Front Leg (model 2320 shown)
slide fro
nt leg on
in direc
tion of a
rrow
the bent tab on the
front leg bottom piece
is visible here
Fig. 8.1.3 Left Front Leg (models 2520/2720 shown)
Fig. 9.1 Install Windshield Support
here and
opposite side
Fig. 8.1.2 Left Front Leg (models 2520/2720 shown)
the top flange of
the front leg is
behind the cowl
locknut on model
2520/2720 only
no bolt used here
on model 2320