p. 5 of 16
3. REAR LEGS (cont’d.)
If installing a hard sided cab,
On model 2720 only,
remove the items shown in figures
3.2 and 3.3 (storage unit, bracket, and hardware). NOTE:
the bracket is press fit onto the ROPS tubing. Pull it off
the tubing by hand.
3.4
Pre-assemble the rear legs to the rear panel as
shown in fig. 3.4. Lay the rear panel down on a soft sur-
face with the left and right sides up in the air. Attach
each rear leg (to the lower, outboard surface of the rear
panel) with three 5/16” x 3/4” long button head bolts, 3
steel washers, and 3 plastic washers on the outside sur-
face and 3 steel washers and 3 locknuts on the inside
surface as shown in fig. 3.4. The top holes are to be left
open for now (see fig. 3.4.1). Tighten these bolts.
3.5
Tip the driver’s seat forward. With assistance, place
the rear panel/rear leg assembly in position as shown in
figure 3.5. Note: the bulb rubber on the bottom can be
lightly pulled so it is facing out of the cab as you are
installing it. Re-install the 4 original equipment bolts, but
do not tighten.
weatherseal
gussets
Fig. 3.5 View from left side of vehicle
Fig. 3.4 View of bottom of rear panel assembly
locknuts on
this side
Fig. 3.4.1 View of top of rear panel assembly
leave open
for now
Fig. 3.3 Storage unit, bracket, and hardware
Fig. 3.2 Storage unit (on 2720 only)
