p. 11 of 16
12. TIGHTEN ALL BOLTS
12.1
Tighten all remaining bolts including the floorboard
bolts on the 2320 (no floorboard bolts used on the
2520/2720).
IMPORTANT: the four (4) bolts that were removed
and re-installed at the base of the ROPS structure
must be torqued properly to meet original equipment
safety standards. These four bolts (M14 diameter) are
to be torqued to 91-108 ft.-lbs. (124-147 N-m).
13. REAR CURTAIN (soft sided cabs only)
13.1 For models 2520/2720 only
, install the 6 supplied
snaps and locknuts to the rear of the roof with the lock-
nuts on the outside surface. Note: extra snaps are provid-
ed in case one gets lost.
13.2 For model 2320 only
, install the 6 supplied snaps
and locknuts to the top filler piece with the locknuts on
the outside surface. Note: extra snaps are provided in
case one gets lost. Ref.: see fig. 5.1 on page 6.
13.3
Attach the top of the rear curtain to the newly in-
stalled snaps. See fig. 13.3.
13.4
Note: adhesive-backed velcro should be applied to
a clean, dry surface at room temperature. Apply self-
adhesive hook velcro, as needed, along the rear legs and
rear panel. See figures 13.4 and 13.4.1. Adhere the rear
curtain to the newly applied velcro strips.
13.5
The bottom of the rear curtain has factory installed
velcro for attaching to the top side of the previously in-
stalled rubber filler.
Fig. 13.3 Soft side rear curtain
attach to
snaps
Fig. 13.4.1 Soft Side Curtain (viewed from the back)
velcro here
Fig. 13.4 Soft Side Curtain (viewed from left side)
velcro here
