Cuppone Pizzaform Series, Instructions For Installation, Use And Maintenance Manual

Page: 26 / 76

10
IV. INSTRUCTION FOR INSTALLATION
1.
Legal and technical regulations and directives
When installing this oven, you must comply with the following:
•
By-laws currently in effect.
•
Local building and fire-prevention regulations.
•
Regulations regarding electrical systems.
•
Accident-prevention regulations currently in effect.
2. Positioning
Unload the machine using suitable mechanical hoisting equipment.
Unpack the appliance and carefully remove the protective film.
Should any glue remain on the surface, remove it using a suitable, non-corrosive solvent.
Dispose of the packaging in according with applicable current regulations.
Check that the appliance is intact. In the event of any defects or breakages, contact the manufacturer for
instructions.
The appliance should be placed on top of the relative support provided by the company, since this sup-
port has been made in keeping with its characteristics.
If the appliance is placed on top of any other base unit, make sure that it is level and capable of support-
ing the weight (see technical data table).
Carry out this operation with the aid of suitable mechanical hoisting equipment, using the eyebolt that is
provided and which should be screwed onto the top of the equipment after having removed the protective
plug.
4.
Electrical connection
Electrical connections must be performed only by a qualified electrician.
The technical data plate located on the back of the appliance contains all the information required for
proper electrical connection.
The appliance must be connected to the mains using a H05 RN-F type power cord.
In order to do that, remove the appliance left side panel, connect the cord to the terminal box and fasten
it with the proper cable glands found on the appliance back.
Connect the appliance to earth and insert it into the unipotential circuit; the terminal for this purpose is to
be found at the rear of the oven and is marked by the international symbol .
Connect the appliance to the electricity supply through a double-pole differential magnetothermal circuit
breaker having a contact separation of at least 3 mm on both poles, which is readily accessible and near
to the appliance.
The manufacturer cannot be held liable in the event of failure to comply with the above.
5. Appliance Check up
To start off the appliance, follow the instructions contained in the paragraph “ Switch on, parameters
setting, switch off ”.
Check the correct working of all electrical parts, explaining to the user how to best operate the appliance
and carry out all ordinary maintenance and cleaning.
GB