Cuppone Giotto GT110, Pre-Installation And Installation Manual

Page: 34 / 42

34
Fig. 36.
Fig. 37.
For a correct electrical connection, the appliance must:
•
be included in an equipotential system in compliance
with the legislation in force. This connection must be made
between the various devices with the terminal marked
with the equipotential symbol
. The cable must have
a maximum cross-section of 10 mm2 (in compliance with
IEC EN 60335-2-42:2003-09) and must be yellow-green;
•
must be grounded to the mains (green-yellow wire);
•
must be connected to a thermal differential switch in
compliance with the regulations in force (0.03A A type);
•
must be connected to an omnipolar circuit breaker allow-
ing complete disconnection in overvoltage III category con-
ditions.
The Manufacturer accepts no liability for failure to comply with
the above.
If required, the cable can be replaced by the Dealer or
its technical service or by a person with similar qualifi-
cations to prevent any risk.
Electrical data
Model
Power
supply
(V)
Power
(kW)
Average
consumption
(kWh)
Absorption
(A)
Connection
cable
(Nxmm
2
)
Customer
panel protection
(nxA)
GT 110
GT110/1TS-C5-CP 3Nx400V
16.25 9.7
23.4 5x4 4x25
GT110/1TS-B5-CP 3x230V 40.7 4x10 3x50
GT110/1TS-B6-US 3x208V 41.7 4xAWG7 3x50
GT 140
GT140/1TS-C5-CP 3Nx400V
19.95 11.9
28.7 5x4 4x32
GT140/1TS-B5-CP 3x230V 50.0 4x10 3x50
GT140/1TS-B6-US 3x208V 50.3 4xAWG7 3x63