CUOGHI mini NEB F3005, Instructions Manual, Page: 11 / 16

11
M869-4_GB_letter
mini NEB
ENGLISH
Pic. 14 - Advanced cleaning of the basin
Remove any dirt that can reduce or stop the fl ow of water.
»
Disconnect the tube P .
»
Remove and clean the syphon S .
» Remove and clean the fl oat
D
: the fl oat cannot be complete-
ly removed because of the wire. Handle and clean it gently,
check that the fl oat can move up and down freely.
»
Clean the entire basin B , taking care to remove the dirt from
the area surrounding the siphon and the fl oat.
Pic. 15 - Advanced cleaning of the parts
5.6 Cleaning of the cone and the disk
Pic. 16 - Th e cone and the disk
»
Remove the cone C by releasing the two tabs t : remove the
cone
C
from the top and gently pulling it up and down until
the two tabs release and the cone eases out.
»
Th e black gasket Or of the cone remains on the bottom of
the disk: gently pry it out and check that it is not damaged.
If it’s compromised; it must be replaced.
» Remove the screw
S
and the disk
D
.
» Clean the cone and the disk, remove any dirt that can reduce
or stop the passage of the water.
Pic. 17 - Th e cone and its gasket
To assemble the cone follow carefully the following instructions.
»
Fix the disk to the motor with its screw and washer: do not
overtighten the screw too much or you can damage the disk.
» Place the black gasket back on the cone C ; wet it with water
before placing back on the cone.
»
Click the cone back in its slots and check it’s in the right
position before snapping it in. Th is is can be tricky: do not
rotate or pull the cone because this will slip the gasket out of
place. Push down the cone gently until you hear the click of
the two tabs t (Pic. 17).