4801-1020
Super-Saver XL
TM
Heater
15
4. User Instructions
Before turning ON gas, check main supply valve to be sure it is open.
all connections for leaks with a Gas Leak Testing solution. (soap and water work well.) Check to see if gas
valve knob is in the ON position. If not, turn counterclockwise until knob “clicks” into the ON position.
(This may not apply to all units.) Turn ON gas by turning the ball valve handle into vertical position.
Figure 4A
Connecting Electrical Power
Make sure a circuit breaker or similar cutoff device is provided to permit disconnection of
electrical power to heater for service and cleaning.
All electrical work should be performed by a
certified electrician. If no adjustments are made, the heater will operate every time power is supplied and
the ON/OFF switch is activated. If an external thermostat is to be used (see component and wiring diagram
), the heater will operate only when power is supplied, the ON/OFF switch is activated, and the
thermostat indicates a call for heat.
Start-Up
Before turning ON gas, verify that the main supply valve is open. Check all connections for leaks with a
soap and water gas leak testing solution. Verify the gas valve knob is in the ON position. If not, turn
counterclockwise until knob “clicks” into the ON position. (This may not apply to all units.) Turn ON gas by
turning ball valve handle into vertical position.
IMPORTANT
:
Heater installation must be performed by a qualified gas heater service personnel.
Follow the below steps to light the pilot and position the gas valve control for use.
NOTE
:
Do not supply power to the heater during this start-up. Supplying power to the heater at this stage
could cause the blower to start which will make lighting the pilot difficult
.
1. Open all manual gas supply valves and check all connections for gas leaks.
2. Position the gas shut off valve (1) to the pilot position.
3. Fully depress the red pilot button, located on the gas valve, while applying a flame to the pilot light
burner. If the red pilot button cannot be depressed the gas shut off knob (1) is not in the PILOT (3)
position.
4. After the pilot light is lit, keep the red pilot button depressed for approximately 30 seconds to heat the
thermocouple.
1
2
3
Ref #
Description
1
Gas Valve “ON” Position
2
To Gas Supply
3
To Heater
