Cubicon 3DP-110F, Operation Manual

Page: 19 / 44

Cubicon Single Operation Manual
(150616,En)
Copyright Reserved HyVISION System Inc. 19 / 44
This document is a general purpose operation manual and is subject to change without notice when necessary
for product improvements. HyVISION System does not take the responsibility for loss caused by any error in the
document or provisions and use of this document.
6.3. Functional Menu during Printer Standby
If
“
6.2. LCD Display of Status
” is shown on the LCD screen of Cubicon Single, press the [ENTER]
button to display the functional menu. You can access each item of the function menu by turning and
pushing the [ENTER] button or pushing the [BACK] button. Press the [HOME] button to return to the
status display window.
The following menu is available when the printer is in standby mode. A different menu is displayed
when the printer is in printing mode.
> SD Card Selects the output file in the inserted SD memory.
> Prepare Preparation for printing
> Preheat
The heating bed and extruder nozzle are preheated to the set
temperature.
> ABS / PLA / U01 / U02 They are preheated to the preset temperature.
> Autotilt Align This tests Auto tilt.
> Load Filament
This inserts a new filament into the extruder.
> Temp This sets the extruder nozzle temperature to use a new filament.
> Load Start
This inserts the filament into the filament entry when the target nozzle
temperature is reached.
> Unload Filament This removes the filament in the extruder.
> Temp This sets the extruder nozzle temperature to remove the filament.
> Unload Start This pulls out the filament when the target nozzle temperature is reached.
> Temperature Printer operation temperature control
> Cooldown Temperature initialization (Heating is stopped to lower the temperature)
> Extruder
Extruder nozzle temperature setting
> Bed Heating bed temperature setting
> Chamber Printer inside maximum temperature setting
> Fan speed
Print fan speed setting
> Motions Printer movement control in standby mode
> Disable stepper This disables the motor to enable manual control.
> Bed Up
The heating bed is lifted.
> Bed Down The heating bed is lowered.
> Extr. Move
The extruder motor is manually rotated (manual lifting or lowering of the
filament).
> Home The X/Y (extruder) and Z (heating bed) are moved to the zero position.
> Parking They are moved to the position (rear center) during idle status.
> Configuration Default setting
> Preheat Temp This sets the preheat temperature.
> ABS / PLA / U01 / U02
Preheat Temp
This sets the preheat temperature according to each condition.
> Extruder Extruder nozzle preheat temperature setting
> Bed Heating bed preheat temperature setting
> Chamber Printer inside maximum temperature setting
> Autotilt This adjusts Auto tilt.
> Bed Offset Offset between heating bed and nozzle after Auto tilt
> Always Autotilt Option to always run Auto tilt before printing.
> Filament Check Option to use the filament supply detection function.
> Filter Fan Filter fan operation setting.
> Baudrate
This sets the communication speed when printing through USB
connection from PC.
> 250000 / 115200 Default 250000, Printing through PC connection(MAC OS) 115200
> Store to EEPROM
The changed settings are saved in EEPROM.
When reboot without saving the changed setting, it cannot apply the
changed setting value.
> Initialize EEPROM The settings are initialized.
> Information This displays the equipment model name and firmware/hardware version.
Note)
The actual menu structure may differ depending on the firmware version.
This document is based on Firmware Ver. 2.0.0, Cubicreator v2.0.