Cubicon Single Operation Manual
(150616,En)
Copyright Reserved HyVISION System Inc. 10 / 44
This document is a general purpose operation manual and is subject to change without notice when necessary
for product improvements. HyVISION System does not take the responsibility for loss caused by any error in the
document or provisions and use of this document.
4. Printer Parts and Accessories
The printer is packaged after a total test of output conditions.
This testing may leave traces of usage on the heating bed, nozzle, etc. Be assured that these are traces of
testing, and that there is no problem with the product.
4.1. External Printer Parts
[1] Top door
Used for maintenance such as the filament replacement (loading / unloading),
separation of detachable extruder, etc.
[2] Front door
Used to pull out the molded part
[3] Inclinometer
Used to check levelness when the printer is installed
[4] Bottom door
Used for cleaning the bottom, etc.
[5] Clean filter case
Used to mount the clean filter
[6] SD memory insertion hole
Used to insert the SD memory
[7] LCD and operating buttons
Used to operate the LCD screen and printer
[8] Filament insertion hole
Used to supply the filament (located at the inner top when the spool door is
opened)
[9] Spool door
The door is used to fix the filament spool
[10] Spool door handle
Used to lock the spool door (should be locked after the spool is mounted)
[11] Spool carrier
Area in which the filament spool is mounted
[12] USB input (Type-B)
USB input terminal to connect to a PC
[13] Power switch
Main power switch for the printer
[14] Power input
Terminal to connect the power source of the printer
[15] Leveling foot
Used to set the horizontal levelness of the printer (4 at the bottom)
2
3
4
5
6
7
10
11
8
9
1
12
13
14
15
