Cubicon Single Operation Manual
(150616,En)
Copyright Reserved HyVISION System Inc. 11 / 44
This document is a general purpose operation manual and is subject to change without notice when necessary
for product improvements. HyVISION System does not take the responsibility for loss caused by any error in the
document or provisions and use of this document.
4.2. Internal Printer Parts and Extruder
[1] Teflon tube
The path to supply the filament to the printer extruder (be careful not to bend,
etc.)
[2] Extruder part
The extruder exudes the filament and melts it through the nozzle
[3] Heating bed
The platform to output the printed material during printing
Extruder part
[E1] Filament insertion hole
Hole through which filament is inserted into the extruder; a Teflon tube is
placed inside it
[E2] Filament handle
Handle to manually pull the filament out of the extruder or insert it
[E3] Mold Lighting LED
White LED to check the molding status;located in the detachable extruder part
[E4] Ventilation guide
A fixture sending the air from the molding fan to the molded parts; located in
the detachable extruder part
[E5] Nozzle
Nozzle through which the melted filament flows;located in the detachable
extruder part
[E6] Detachable screw
Fastening screws used to mount and dismount the detachable extruder part
[E7] Fixed extruder part
Fixed part of the extruder
[E8] Detachable extruder part
Detachable part of the extruder
Do not touch the nozzle and heating bed of the detachable extruder during the printing operation, as these
are hot.
E4
E2
E6
E7
E8
E3
E1
E5
1
2
3
