76
15=61440
Switch(config-if-PORT-
PORT)# spanning-tree edge
Specify the port as edge
port so to enable it to
move directly to forwarding
state upon link-up.
Switch(config-if-PORT-
PORT)# spanning-tree p2p
[forced_true|forced_false|auto]
[forced_true|forced_false|auto] Specify the port as point to
point port and its mode.
No command
Switch(config-if-PORT-
PORT)# no spanning-tree
Disable spanning-tree
protocol.
Switch(config-if-PORT-
PORT)# no spanning-tree
cost
Undo specify port path
cost.
Switch(config-if-PORT-
PORT)# spanning-tree priority
Undo specify bridge
priority.
Switch(config-if-PORT-
PORT)# no spanning-tree
edge
Undo specify the port as
edge port.
Switch(config-if-PORT-
PORT)# no spanning-tree p2p
Undo specify the port as
point to point port.
14. Set up port speed.
Command
Parameter
Description
Switch(config-if-PORT-PORT)#
speed [1000|100|10]
[1000|100|10] Set port speed as 1000Mbps, 100Mbps or
10Mbps.
Note1 : Speed can only be configured
when auto-negotiation is disabled.
Note2: Fiber ports can not be
configured as 10Mbps.
No command
Switch(config-if-PORT-PORT)#
no speed
Undo port speed setting.
15. Set up VLAN parameters per port.
Command
Parameter Description
Switch(config-if-PORT-PORT)#
vlan dot1q-vlan access-vlan [1-
4094]
[1-4094]
Configure port PVID.
Switch(config-if-PORT-PORT)#
vlan dot1q-vlan trunk-vlan [1-
4094]
[1-4094]
Configure port VID.
Switch(config-if-PORT-PORT)#
vlan dot1q-vlan mode access
Configure port as dot-1q access port.
Switch(config-if-PORT-PORT)#
vlan dot1q-vlan mode trunk
Configure port as dot-1q trunk port.
