Chapter 4. Web Configuration & Operation
124
CHAPTER 3
WEB OPERATION & CONFIGURATION
Priority:
The priority to be inserted in MEP source direction. On Caracal, this priority is also used in sink direction
(client layer). On Serval, for each client EVC, the highest COS-ID (ECE Class) is used.
Frame Rate:
Select the frame rate of LCK PDU. This is the inverse of transmission period as described in Y.1731.
Click the “Performance Monitoring” button.
Performance Monitoring Data Set
Enable:
When enabled, this MEP instance will contribute to the Performance Monitoring Data Set gathered by the
Performance Monitoring session.
Loss Measurement/Loss Measurement State
Enable:
Loss Measurement based on transmitting/receiving CCM or LMM/LMR PDU can be enabled/disabled - see
'Ended'. This is only valid with one Peer MEP configured.
Priority:
The priority to be inserted as PCP bits in TAG (if any). In case of enable of Continuity Check and Loss
Measurement both implemented on SW based CCM, 'Priority' has to be the same.
Frame rate:
Select the frame rate of CCM/LMM PDU. This is the inverse of transmission period as described in Y.1731.
Selecting 300f/sec or 100f/sec is not valid. In case of enable of Continuity Check and Loss Measurement both
implemented on SW based CCM, 'Frame Rate' has to be the same.
Cast:
Selection of CCM or LMM PDU transmitted unicast or multicast. The unicast MAC will be taken from the 'Unicast
Peer MAC' configuration. In case of enable of Continuity Check and dual ended Loss Measurement both implemented
on SW based CCM, 'Cast' has to be the same.
Ended:
Summary of Contents for FRM220-MSW404
Page 1: ...1 FRM220 MSW404 L2 OAM Managed Carrier Ethernet Switch ...
Page 179: ......
