6
CTC EcoPart i425-i435 Pro
General Information
Check list
The check list must be completed by the installer.
• If service is needed, you may be required to provide this document.
• Installation must always be in accordance with the installation and maintenance instructions.
• Installation must always be carried out by an MCS accredited installer.
Following installation, the unit must be inspected and functional checks performed as
indicated below:
Pipe installation
Heat pump filled, positioned and adjusted in the correct manner according to the instructions.
Heat pump positioned so that it can be serviced.
Capacity of the charge/heating circ pump (depending on type of system) for the flow required.
Open radiator valves (depending on type of system) and other relevant valves.
Tightness test
Bleed the system
Check proper operation of the requisite safety valves.
Requisite waste pipes connected to the floor drain (depending on type of system).
Electrical installation
Power switch
Correct tight wiring
Requisite sensors fitted
Accessories
Information for the customer (adapted to current installation)
Start-up with customer/installer
Menus/controls for selected system
Installation and maintenance manual supplied to the customer
Checks and filling, heating circuit
Information on fine adjustments
Alarm information
Functional test of safety valves fitted
Information on procedures for fault registration
______________________________________ ______________________________________
Date / Customer
Date / Installer
Summary of Contents for EcoPart 425-435
