CTA
Instruction Manual
MPE
Reference: MT0027DA
This document may be modified without prior notice
11
Revision date: 11/05/06
Even partial reproduction is prohibited without authorisation in writing
5.5
Choice temperature unit
•
Press both
and
buttons simultaneously for 15 seconds.
•
Use the
buttons to select the temperature unit shown on the LEDs.
•
To record the new unit, wait 5 seconds without pressing a key. The digital display panel reverts to its normal
status (i.e. stops flashing).
6
Maintenance preparation
6.1
Shut down and close all circuits
Various risks (flying objects, explosion, noise, electrocution...):
Always turn off all circuits before working on the drier. Follow the procedure below:
1.
Open the by-pass valve
2.
Close the upstream valve
3.
Close the downstream valve
4.
Set the master switch to O.
5.
Depressurise the drier with the TEST button until internal pressure is zero.
6.2
Access inside the drier
Various risks (electrocution, explosion...): Before working inside the drier, turn the appliance OFF as
stipulated in § 4.1.
•
Lock the power supply cut-out switches OPEN.
•
Lock the upstream and downstream valves CLOSED and the by-pass valve OPEN.
•
Check that the appliance is depressurised by pressing the TEST button.
After carrying out the three procedures above, proceed as specified below for your drier model.
MPE 006 and 008
•
unscrew and withdraw the lower screws of the front panel and slide it upwards to release the lock tabs.
Take off the front panel.
MPE 010 to 125
•
unscrew and withdraw the back screws of the upper panel and slide it backwards to release the lock tabs.
Take off the upper panel.
•
Otherwise, unscrew and withdraw the lower screws of the front panel and slide it upwards to release the
lock tabs. Take off the front panel.
You can now work inside the drier risk-free.
6.3
Closing
Various risks (electrocution, explosion...): After having opened the appliance as stipulated in § 4.2
and before trying to restart the drier, you must carry out the operations detailed below.
After maintenance, proceed as specified below for your appliance model.
MPE 006 and 008
1.
Replace the front panel by sliding it downwards to engage the lock tabs. Screw up the lower screws of the
front panel.
!
!
!
