SIGNATURE 2 SERIES
Electronic Connections
P - Power Supply
B - Powered in Backwash Cycle Only
S - Powered in Entire Regeneration Cycle
-Electrical Connections
-
1. Connect the power supply to the control valve and plug into a 115 volt / 60 Hz receptacle.
Note :
DO NOT plug into an outlet controlled by a wall switch or pull chain that could inadvertently be turned off.
2. Plug peroxide feed pump into pressure switch receptacle.
-Pressurizing The System
-
1. Make certain Signature Series 2 Control Valve is in the SERVICE position.
2. Slowly rotate the handle of the bypass valve to the SERVICE position parallel with the plumbing.
3. Open the nearest faucet to evacuate air from plumbing lines
4. Check for leaks!!
Installation
7
P B S
