CSI Wireless SBX-3, Reference Manual

Page: 85 / 110

SBX-3 Reference Manual
67
Field Description
CS0 Channel 0
PXXX-
Y.YYY
Resident SBX-3 firmware version
S/N SBX-3 receiver serial number
fff.f Channel 0 current frequency
M Frequency Mode (‘A’ – Auto or ‘M’ – Manual)
ddd MSK bit rate
R RTCM rate
SS Signal strength
SNR Signal to noise ratio
MTP Message throughput
Q Quality number {0-25} – number of successive good 30 bit RTCM words
received
ID Beacon ID to which the receiver’s primary channel is tuned
H Health of the tuned beacon [0-7]
T $PCSI,1 status output period {0-99}
Optionally, the Status Line A query can be issued requesting the output
of the response message at a specified output rate. It has the following
format, where T is the output period in seconds:
$PCSI,1,T<CR><LF>
Response:
$PCSI,ACK,1
$PCSI,CS0,PXXX-Y.YYY,SN,fff.f,M,ddd,R,SS,SNR,MTP,Q,ID,H,T
Cycling receiver power discontinues the output of this message.
Additionally, message output can be halted by issuing the
$PCSI,1<CR><LF> query without the output period field.
The response message has the same format as discussed above. In
addition to this modified version of the Status Line A command, an
additional S field may be placed after the T field, resulting in the
following command: