Form I-RA/D 350/500, Page 4
Use
This heater is for commercial or industrial use only.
The heater should be installed by an experienced installer thoroughly
trained and experienced with the installation of oil-fired appliances. The
installer should be familiar with the special precautions necessary in the
handling and storage of used automotive oils which may contain small
amounts of gasoline.
Installation must comply with:
In the United States
■ The Standard for the Installation of Oil Burning Equipment NFPA 31
■ The National Electrical code ANSI/NFPA 70
■ Federal, State, and local municipal codes
In Canada
■ CSA Standard B139-M91, Installation Code for Oil Burning
Equipment
■ CSA Standard C22.1-Canadian Electrical Code, Part 1
■ Federal, Provincial, and local municipal codes
■ Installation, operating and maintenance permits may be required
from regulation authorities covering environmental quality fuel,
fire and electrical safety. Municipal permits may also be required.
■ Regulation requires that only used oil generated on the premises
of the owner may be burned in this equipment unless written
authorization is obtained from the regulatory authority.
WARRANTY IS VOID IF ....
1. Heater is not installed in accordance with these instructions
and applicable codes and ordinances.
2. Wiring is not in accordance with diagram furnished with the
heater.
3. Heater is operated in presence of chlorinated vapors.
4. Air through the heater is not in accordance with the rating
plate.
5. Ducts are attached to RA (fan) model
6. Heater is not maintained in accordance with maintenance
requirements. FAILURE TO CLEAN THE COMBUSTION
CHAMBER ON A REGULAR BASIS.
7. Other-than-specified fuel is burned.
8. Heater is operated at elevations greater than 3,000 ft (914M)
above sea level without factory approved modifications.
9. Fuel input capacity is altered.
Introduction
Codes and
Regulations
Warranty
For Warranty information,
refer to the Limited Warranty
form in the Literature Bag.
Installation
Summary of Contents for RA 350
