CS RV50, Instruction Manual

Page: 12 / 50

RV50 Sierra Wireless AirLink® 4G LTE Cellular Modem
4
into the upper slot until it stops and locks into place. To eject the SIM
card, press it in slightly and release.
3. Replace the SIM card cover.
FIGURE 4-1. SIM Card Installation
4.3 Configure RV50
QuickStart describes configuring the RV50 in serial server mode.
It may also be configured in Point-to-Point Protocol (PPP) mode.
For a description of the modes, see Section
5 , Overview
(p. 9)
. For
instructions on setting up the RV50 in PPP mode, see Section 7.5 ,
ACEmanager and Template Files
(p. 18)
, and Section 7.6 , Enabling
PPP Mode
(p. 20)
.
The RV50 is configured using ACEmanager , a web based configuration tool
hosted by the RV50. ACEmanager can be accessed using Internet Explorer® or
Firefox® remotely over the cellular WAN or locally over Ethernet. A number
of templates will be provided for download to make most configurations very
simple once connected to
ACEmanager .
1. Download Campbell Scientific’s collection of RV50 configuration
templates from
www.campbellsci.com/downloads and run the executable
downloaded. The templates can also be found on the Campbell Scientific
ResourceDVD .
2. Connect the Cellular antenna.
3. Connect the Diversity antenna, if used. Recommended but not required.
Note: If a Diversity antenna is not used, use ACEmanager to disable
WAN/Celluar | Network Credentials | RX Diversity .
NOTE