12
MAB 465
GB
Inserting the tool
WARNING
Risk of injury!
►
Do not use damaged, contaminated
or worn tools.
►
Change tools only when the machine
is switched off and at a standstill. Pull
the plug out of the mains socket.
►
After inserting, check that the tool is
engaged securely.
►
Only use tools, adapter and accesso-
ries that match the machine.
The machine is equipped with a 19 mm
(3/4) Weldon direct tool mounting.
Inserting the tool with Weldon shank
(see fig. 3)
Inserting the tool
Before mounting, clean the Weldon
shank of the tool and tool mount of the
machine.
Check the cable connection for
grease.
Untighten both hexagonal socket
screws in the tool mount with the Allen
wrench (A) supplied.
Insert the tool in the tool mount.
NOTE
►
Insert the appropriate ejector pin
(B,C) before inserting a core drill.
Tighten both hexagonal socket screws
in the tool mount with the Allen wrench
(A) supplied.
Removing the tool
Untighten both hexagonal socket
screws in the tool mount with the Allen
wrench (A) supplied and remove the
tool from below.
Preparation
WWW.CSUNITEC.COM
