Provide Electricity
Ensure that the available power supply matches the cooler’s voltage specifications indicated on the
nameplate label (located at the top/rear of unit).
Plug power supply cord into receptacle.
Please ensure that cooler is set up so as access to the power outlet and plug is unobstructed.
Note: To provide additional protection from the risk of shock, this unit MUST be connected to a ground
fault circuit interrupter (GFCI) outlet at all times. Use of an extension cord will void any warranties.
Prime Water System (Required during initial setup and after replacement of
CrystalFlo Water Cartridge)
Depress the
water lever to fill the hot tank.
Hot
When water begins to flow from the hot outlet the tank is full (approx. 1 minute)
The Cold water tank will fill automatically (approx. 3 minutes)
Activate Heating Function
(H&C Model Only)
Ensure Priming of Hot water system is complete before starting this step
Notice: Hot (Heated) water will not be dispensed by the cooler until the hot
switch has been activated (located at the top/rear of unit).
Turn on the hot water switch
- To disable the heating function (Hot Water), turn off the hot water switch
(Figure 9)
DO NOT
draw water from the cooler for about 30 minutes to let the water cool or
heat.
Optimum water temperatures will be reached after several hours of operation.
DISPENSING WATER
The CrystalFlo Water Cartridge has been tested and sanitized prior to packaging. During transit dust
and odors may accumulate in the water tanks and lines. Dispense and dispose of at least 1 quart (1
Liter) of water prior to drinking any water.
Cold Water Dispensing
The temperature control of the cold water is preset to dispense water between
37-50°F (3 to 10°C)
Optimum cold water temperatures will be reached after 1-2 hours of operation.
During this time the compressor could run continuously. This is normal.
1. Position bottle, glass or other container below water outlet
2. Depress (push downwards) cold water lever to start cold water flow
(Figure 10)
3. Release cold water lever once desired fill level is achieved
Hot Water Dispensing
The temperature control of the hot water is preset to dispense water between 169-203°F (76 to 95°C)
CAUTION
This unit dispenses water at temperatures that can cause severe burns.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
Figure 9
Figure 10
