Issue 1
21
The switch on the top left of the tesc valve must be pushed right to the on position with the batteries
installed in the valve
5.4 Tesc remote control STARTING THE FIRE
First thing to start the fire is to unlock the handset by wrapping your hand around it and having your
fingers on one side and the palm of your hand on the other
when you do this the handset will unlock and the green light will stay solid
With the green light solid put your finger on the on/off button and hold it there for approximately 3
seconds ,
(and then remove finger from the on/off button )
at this time the red ACTIVITY light
will come on and flash ,the appliance will spark and then come on to main burner and which point
the red light will stop flashing
Warning :
the above procedure is a safety issue so must be followed correctly or your appliance
will not come on (it may take a couple of goes to master but it is easily learnt )
When the burner is lit the appliance can be adjusted from high to low and vice versa , to do this the
handset must be held by wrapping hand around to unlock and with the green light solid touch the
or to alter the burner to high or low
To turn the fire off simply press the ON / OFF Button whilst hand wrapped around handset and
green light solid , the appliance will turn off very easily as this is not a safety issue .
Whenever you operate the appliance with the handset the red light will flash to indicate the
appliance and handset are communicating with each other
on / off
If you misplace the handset you can page it by pressing the + button on the appliance for approx 5
seconds . the handset will flash make a noise to help you locate it , by picking up the handset the
paging will stop .
Always make sure you put decent quality batteries in handset and the gas valve for best use
Any problems with the appliance always check batteries in the fire and
remote control and if necessary replace
To un pair handset hold the set button continuously until green & red lights are flashing then
immediately remove the batteries for 3 minutes
With the handset within 1 metre of gas valve
To re-pair the handset press the + and - on the appliance simultaneously until red indicator
light comes on approx 10 seconds (indicator light located on control above buttons )
immediately within 1 second remove fingers from + and - and press the on / off button on the
gas valve , the handset will beep and then immediately pick up handset hold in hand and
press
SET
for 3 seconds , the handset will be paired
