RADIO REPLACEMENT
SWC RETENTION
+
+
R
INTERFACING SOLUTIONS
DKFD-60L
Radio Replacement Interface with Steering Wheel Control Retention
with Dash Kit for FORD, LINCOLN & MERCURY
Crux Interfacing Solutions • 21541 Nordhoff St., Unit C, Chatsworth, C
A
91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
rev.051619
2 of 7
INSTALLATION DIAGRAM:
AFTERMARKET
RADIO
+12V Constant Yellow
+12V ACC Red
12V Ground Black
Illumination Orange
Vehicle Speed Sense Red/White
(or Brown)
Subwoofer Amp Turn-on Blue/White
Antenna Turn-on Blue
Right Front (+) Gray
Right Front (-) Gray/Black
Left Front (+) White
Left Front (-) White/Black
Right Rear (+) Violet
Right Rear (-) Violet/Black
Left Rear (+) Green
Left Rear (-) Green/Black
Subwoofer
Factory Aux Input
24-Pin
Plug*
16-Pin
Plug*
8-Pin
Plug*
TO FACTORY
HARNESS
12-Pin
Connector
SWC TYPE
(Connect PINK to PINK wire)
Subwoofer
Converter
Module
*Inspect that the male pins are
properly lined up before plugging
into the factory harness.
SWRFD-60L
MODULE
ON R
ADIO
VEHICLE
1 2 3 4 5 6 7 8
AFTERMARKET
RADIO SELECTOR
(See Chart)
FORD
SWC SETTING
(OFF OFF OFF OFF)
ON RADIO VEHICLE
1 2 3 4 5 6 7 8
Cap or insulate if
not being used
Kenwood/JVC (BLUE / YELLOW)
Insulate with tape
if not being used
3.5MM SWC CABLE
Plug in the 3.5MM SWC cable to the 4-pin port
on the module. See “DIP SWITCH SETTINGS” section.
LIN BUS (Green)
Blue/Yellow
(Not Used)
1. Only supports analog Steering Wheel Control type.
2. Use part number SWRFD-60 for CAN Bus Steering Wheel Control.
3. Output signal stated above may not cover all Year/Model.
4. Does not retain SYNC.
5. Not compatible with factory-installed Sony systems and THX systems with amplifier.
NOTES: