CrustBuster BeltVeyor Crescent, Owner'S Manual

Page: 8 / 48

6
Pre-Operation Check List
1. Check all bearings for proper lubrication.
2. Check the tube for foreign material.
3. Check all belts for proper tension.
4. Start unit and check conveyor belt alignment while unit is empty.
BELT CARE ………
It is suggested that the unit be run every two to three days or more often if possible. This tends to
keep the conveyor belt alive and stops any forming of the belt to the curvature of the tube while the
unit is not in use.
NOTE: Belt may deteriorate if not in use and exposed to weather conditions for any prolonged
period of time.
Operation Sequence
1. Check wheels to prevent movement during operation.
2. Check all drive belts for proper tension.
3. Make sure conveyor belt is properly tensioned.
4. Allow unit to run empty for a few minutes to flex conveyor belt.
5. Check conveyor belt for proper alignment.
6. Charge conveyor unit as evenly as possible. DO NOT bury intake end in material.
7. Before shutting power off, be certain unit is empty.
PTO DRIVE OPERATION ………
While operating, keep PTO shaft as straight as possible. Prolonged operation with the PTO
shaft at an angle in excess of 15 degrees will reduce U-joint life. DO NOT extend PTO shaft
beyond
80" end to end.
OPERATION WITH ACCESSORIES ………
If the BeltVeyor is used with a self-powered undercar conveyor, start the BeltVeyor first and
the undercar conveyor second. Reverse this procedure for shutdown.
TOWING ………
The BeltVeyor tubular conveyor is designed for maximum portability. Observe the following
towing instructions for both safety and care of the unit.
1. Lower the unit to the extreme down position with slight tension on the cable.
2. Deflate tires to approximately 22 pounds.
3. Make certain the hitch is secure.
4. Be sure to follow normal towing safety precautions.
STORAGE ………
Temporary Storage
1. Relieve tension from all belts; both v-belts and conveyor belt.
2. Store all belt equipment in a dry place. If equipment cannot be stored out of the weather,
cover electrical and mechanical parts with waterproof material.
Prolonged Storage
1. Remove all belts and store in a cool, dark, dry place.
2. Wash conveyor belt thoroughly.
3. Wash conveyor tube both inside and out.
4. Lubricate all bearings.
5. Lower unit to the extreme down position with slight tension on the winch cable.
6. Store all equipment in a dry shelter.