Crown Boiler FWZ Series, Installation Instructions Manual

Page: 11 / 56

9
WARNING
• Do not omit the blanket when called for in the table above.
• Do not add any extra baffles beyond those prescribed for the model/burner combination
shown in Table 4.1.
Doing either of these things could cause accelerated chimney deterioration due to
condensation or inadequate draft resulting in severe property damage, personal injury or
death.
FIGURE 4.0: RATING PLATE LOCATION
TABLE 4.1: BASIC BOILER CONFIGURATIONS
Model
Boiler
Part No.
Burner
Burner
Carton
Part #
Blanket
Burner
Tube
Insulation
2nd Pass
Baffle
(410009)
2nd Pass
Baffle
(410008)
3rd Pass
Baffle
(410007)
FWZ060 FWZ002
1
Beckett
2
41060B No No No No Yes
FWZ080 FWZ002
1
Beckett
2
41080B No No Yes
3
No Yes
FWZ081 FWZ003
1
Beckett 41081B Yes
3
No No No Yes
3
FWZ081 FWZ003
1
Riello 41081R Yes
3
Yes No No Yes
3
FWZ081 FWZ003
1
Carlin 41081C Yes
3
Yes No No Yes
3
FWZ100 FWZ003
1
Beckett 41100B No No No Yes
3
No
FWZ100 FWZ003
1
Riello 41100R No No No Yes
3
No
FWZ100 FWZ003
1
Carlin 41100C Yes
3
Yes No Yes
3
Yes
3
FWZ130 FWZ004
1
Beckett 41130B No No No Yes No
FWZ130 FWZ004
1
Riello 41130R No No No Yes No
FWZ130 FWZ004
1
Carlin 41130C Yes
3
Yes No Yes Yes
3
FWZ160 FWZ005
1
Beckett 41160B No No No Yes No
FWZ160 FWZ005
1
Riello 41160R No No No Yes No
FWZ160 FWZ005
1
Carlin 41160C Yes
3
Yes No Yes Yes
3
1 Boiler PN may contain additional characters after those shown to designate other options
2 FWZ060 and FWZ080 not available with Carlin or Riello Burner.
3 Included in burner box.
Figure 4.2 identifies the type and location of baffles. When used, lay the refractory blanket in the combustion chamber with
the 19-1/2” side oriented as shown in Figure 4.2. Line the front edge of the blanket
up with the edge of the combustion chamber.
The blanket should run the entire length of the chamber. No adhesive is required to hold the blanket in place.
When required, burner tube insulation is applied at the factory and secured in place with masking tape. This tape is only needed
to hold the insulation in place while the burner is being installed through the door. After installation, the tape will harmlessly burn
away and the insulation will be secured by the door refractory.