-Translation of the original language-
13
6.4. PRCD safety switch (see Fig 14)
1. Insert the mains plug into a stationary socket.
2. Push the RESET button („0“): The status
indicator light (20) should be lit in RED.
3. Push the button marked „T“: Now, the status
indicator light should go out.
4. Push the RESET button („0“) to start using the
tool.
Do not use the tool if the functional test described above failed.
6.5. Before Start-up
Check the following points:
1. Keep the mains lead away from moving parts.
2. Make sure that the voltage of the motor
correspond to the mains voltage (230V,
50Hz).
3. Make sure to use a grounded mains
connection (wall socket).
4. Make sure that the mains lead and plug are in
a good condition without loose ends or
damage.
5. Place the cutting machine on a flat surface to
prevent instability.
6.6. Starting the tool
Do not apply side-pressure to the
diamond blade. This can lead to
damage on the blade and the risk of
personal injuries.
1. Insert the mains plug into a socket with safety
contact. The safety contact must be protected
with a fuse e.g. in the terminal box. If an
extension cable is required, please note that
with an extension length of up to 20m, a cable
with a cross section of 1.5mm² must be used.
2. Always check the functionality of the PRCD
safety switch as described in chapter 6.4
before switching on the tool.
3. For starting the tool, press the green button marked “I”.
4. For stopping the tool, press the red button marked “O” (see Fig 15).
5. Making a straight cut. Loosen the locating screw (17). Adjust the angular guide in
straight accordance with the gauge (18). Set the necessary width by adjusting the
inner fence. Position the tile against the fence and the angular guide (6) and move the
blade with a soft movement. Do not put too much pressure on the tile to prevent the
motor from overloading.
32
