8
49-3000063
Getting started
USING THE DR
YER
O
M
eDry
Reduces the total energy consumption of specific dryer cycles by adjusting certain heat settings .
NOTE: Cycle times will change when e-Dry is selected.
The
eDry
option will default to on
for
Cottons
. For optimal energy savings, turn
eDry
on . For optimal drying times, turn
eDry
off .
Energy savings will vary across loads and cycles .
This cycle can be used with
Cottons
,
Mixed Loads
,
Towels/Sheets
,
Delicates
,
Bulky Bedding
,
Perm Press/Casuals
and
Quick Dry
. When the
eDry
button is pressed, cycle settings change to
reduce the total energy consumption of the selected sensor cycle .
Lock Controls
You can lock the controls to prevent any selections from being made . Or you can lock or
unlock the controls after you have started a cycle .
Children cannot accidentally start the dryer by touching buttons with this option selected .
To lock/unlock the dryer controls, press and hold the
eDry
button for 3 seconds . A sound is
made to indicate the lock/unlock status . The indicator light above the button will illuminate
when the controls are locked .
NOTE
: The
Power
button can still be used when the machine is locked .
L
N
Clean Filter Message
This message represents only a reminder and does
not
always appear when the filter needs
cleaning . The filter should be cleaned after every drying cycle is complete .
This message will disappear after the
Start/Pause
button is pressed . Even though you may
have already cleaned the filter (before or after the
Power
button has been pressed), the
“
Clean Filter
” message will still be displayed until the
Start/Pause
button is activated .
Display
Displays the approximate time remaining until the end of the cycle .
As the cycle begins, you will see an initial approximate total cycle time in the display .
Then lights will “race” in the display . This means the dryer is continuously monitoring the
amount of moisture in the load . The lights will continue until the dryer senses a low level of
moisture in the load . At that point, the dryer will calculate and display the approximate time
remaining .
Volume
Alerts you that the cycle is complete . The beeper will continue to sound every minute for the
next 5 minutes, until the clothes have been removed . The clothes should be removed when
the beeper goes off so wrinkles don’t set in .
Press
Volume
to select low, medium or high volume, or to turn the beeper off .
To turn on or off the sounds the buttons make when pressed, press and hold the
Volume
button for 3 seconds .
Hold To Lock Controls
eDry
P
My Cycle (on some models)
Set up your favorite combination of settings and save them here for one touch recall .
These custom settings can be set while a cycle is in progress .
To store a
My Cycle
combination of settings:
1 . Select your drying cycle .
2 . Change
Temp
and
Level
settings to fit your needs .
3 . Select any drying options you want .
4 . Press and hold the
My Cycle
button for 3 seconds to store your selection . A beep will
sound and the button will light up .
To recall your stored
My Cycle
combination:
Press the
My Cycle
button before drying a load .
To change your stored
My Cycle
combination: Repeat steps 1–4 .
My
Cycle