16
49-3000063
Optional Instructions
INSTALLING THE STACK BRACKET KIT
INSTALL RUBBER PADS TO
DRYER BASE
Locate the 4 rubber pads in the parts package .
Remove the adhesive backing and firmly place over
each bracket where you removed the leveling legs .
2
PREPARE WASHER AND DRYER
A.
Place the washer in the approximate location .
B.
Make sure the washer is level . Refer to washer
Installation Instructions for details .
C.
Reverse dryer door swing if desired . See Optional
Instructions in this manual for details .
NOTE:
The washer door swing is not reversible .
4
REMOVE THE DRYER
LEVELING LEGS
A.
Carefully lay the dryer on its side . Use the packing
material so you don’t scratch the finish on the dryer .
B.
Use an open-end wrench or pliers to remove the
dryer leveling legs .
1
INSTALL BRACKET TO DRYER
A.
Align the holes in the left bracket with the holes in
the bottom left corner of the dryer . Use a Phillips
screwdriver to install the 2 #12 x 1” tapping screws .
B.
Repeat the above step with the right bracket on
the bottom right corner of the dryer .
C.
Set the dryer upright .
NOTE:
Make sure to set the dryer on a piece of
packing material so the brackets that are attached to
the bottom of the dryer do not damage the floor .
3
Place pads over
all four leveling
leg brackets
Back out and remove
all 4 leveling legs
Install
brackets
on bottom
back
Bottom
of dryer