Owner's Manual
VE-1P Vertical Edger
Page 21 of 33
SECTION 5 (continued)
EDGER START-UP
1)
Turn the spindle switch to “ON”.
2)
Place the conveyor and coolant pump toggle switch in the “ON” position.
Note - the coolant is streaming directly on the wheel.
3)
Make sure the conveyor drive toggle switch is in the “Forward” position.
Do not run glass unless coolant is flowing to the wheel at the point
where the wheel contacts the glass. If a diamond wheel is run dry, the
heat generated may break the glass and damage the wheel. Never
exceed glass capacity of the edger as listed in “SPECIFICATIONS” in
Section 2.
4)
Load the glass onto the infeed rack (left side, when facing the front of the
edger) and convey the glass by hand until it reaches the conveyor belt pad.
The front pressure roll and rear conveyor will grip the glass and begin the
normal operation.
CONVEYOR ADJUSTMENT
To adjust the ingoing and outgoing conveyors, remove the guards and loosen
the 3/8 hex head bolt located just above the adjusting screw. Loosen the jam
nut and turn the adjusting screw to the desired position.
Do not
adjust the
eccentrics near the spindle (grinding section). These are factory set. Once
adjusted, repeat the procedure on the other conveyor.
