background image

REVERSE (MIRROR) IMAGING: 

 

The SV-5200.IR and SV-5200.IR.C Cameras have built-in circuitry to “mirror” the image so objects on 
the right of vehicle appear on the right and objects on the left appear on the left when looking at a 
standard monitor.  If your existing monitor or in-dash monitor has a reverse camera input where the 
monitor itself performs the mirror image, then your picture will not be correct. If this happens, the SV-
5200.IR cameras have  a jumper plug that can be connected  to reverse the image back to normal. 
(See Wiring Diagram) 

 

 
WIRING: 

 

1.  Carefully choose  a hidden out-of-sight location (possibly behind the plate)  for drilling the cable 

hole.  Some vehicles may have an existing hidden rubber grommet or plug available to avoid 
having to drill into the body.  Be sure to double-check for any wiring or obstructions behind the 
surface where you are going to drill the cable hole.  Use the rubber grommet to make a watertight 
seal for the cable where it passes into the vehicle. 

2.  Choose a convenient place to run the camera cable up the left, right or center of the vehicle.  As 

a rule of thumb, try to avoid main factory harness looms that may contain high levels or RF noise 
or interference. 

3.  You can connect the camera power at the rear of the vehicle behind the reverse lights. You may 

also connect power inside the vehicle under the dash or in the trunk. The Red power wire goes to 
Reverse Light +12V, and the Black wire to Ground. The small white plastic plug is for reverse or 
normal image switching. Leave the jumper disconnected for reverse image, connect the jumper 
for normal image 

4.  Run the Yellow RCA video cable to the monitor’s video input or reverse camera input. Leave the 

white RCA disconnected.  

 

 

MONITOR

BLACK

RED

Connect to +12V

Reverse Light

Ground

Connect to RCA

Video Input of 

Monitor

YELLOW

SV-5200.IR CAMERA

BLACK

POWER PLUG

WHITE

No Connection

NORM / REV

IMAGE PLUG

Connect Jumper for

Normal Image

 

Summary of Contents for PlateCam SV-5200.IR

Page 1: ... look of your Car SUV Truck or Van The 180 ultra wide angle CMOS color camera provides rear images in real time and eliminates the dangerous blind spot directly behind your vehicle when backing Works well in day or night on most vehicles Normal or Reverse Image Selectable The plate cam easily connects with other SecurView monitor or aftermarket monitor that uses an RCA input Available in black and...

Page 2: ...ed to use the existing License Plate mounting equipment SIDE VIEW License Plate Camera Lens Mounting Surface Cable Factory License Plate Bolt NOTE License Plate Should Not Be Cut Or Trimmed CAMERA 1 The Camera has built in circuitry to reverse the image so objects on the right of vehicle appear on the right and objects on the left appear on the left when looking at a standard monitor See Reverse I...

Page 3: ...ing to drill the cable hole Use the rubber grommet to make a watertight seal for the cable where it passes into the vehicle 2 Choose a convenient place to run the camera cable up the left right or center of the vehicle As a rule of thumb try to avoid main factory harness looms that may contain high levels or RF noise or interference 3 You can connect the camera power at the rear of the vehicle beh...

Page 4: ...d all State or Federal Motor vehicle codes with regards to modifications of vehicle license plates The manufacturer of the PlateCam assumes no liability or responsibility whatsoever with regards modifications of the license plate www crimestopper com email crimestopper com Phone 800 998 6880 FAX 805 581 9500 2010 Crimestopper Security Products 7 15 2010 SPECIFICATIONS 1 4 Inch Color CMOS Sensor Vi...

Reviews: