WIRING
GRAY WIRE: (-) AUXILIARY REMOTE OUTPUT 1 (Optional,
requires relay)
Connect to terminal 85 of relay. Connect terminal 86 to constant. Connect terminal 87 to +12V or Ground depending
on the type of circuit that needs to activated. Connect terminal 30 to the device/circuit to be activated. Controlled by
pressing and holding Button (3) Trunk Pop for more than 1 second.
845 RED/WHITE / 855-GREEN WIRE: (-) AUXILIARY REMOTE OUTPUT 2 (Optional, requires relay)
This wire connects the same way as Remote Output 1 see GRAY WIRE above. Controlled by Pressing and Holding
Button (1) Lock for more than 1 second.
ORANGE WIRE: NEGATIVE ARMED OUTPUT
This wire provides a GROUND output when system is locked with the remote transmitter. This output can used for an
starter disable relay or a device such as a window roll-up module. For a Starter Disable Circuit, a relay is required.
(Not included) Cut starter wire and connect to terminals 87A and 30 on relay. Connect orange wire to 85 and connect
86 to an IGNITION source that has voltage in the ON and CRANKING position. See Wiring Diagram.
BLACK WIRE: SYSTEM CHASSIS GROUND
THIS WIRE MUST BE CONNECTED TO CHASSIS METAL OF THE VEHICLE. Scrape away any paint or dirt from
the connection point to ensure a good connection. Keep ground wire short and try not to use factory ground locations.
845-BLACK/WHITE WIRE E: (-) DOME LIGHT
ILLUMINATION OUTPUT (Optional, may require
external relay):
Connects to Dome light activation
circuit for Negative dome light systems or to terminal
85 of an external relay for Positive circuits.
JUMPER
PLUG
SIDE VIEW
JUMPER
PINS
*NEGATIVE DOME
CS855RKE MODULE
POSITIVE DOME
*DEFAULT SETTING IS NEGATIVE
NOTE: DOES NOT APPLY TO CS-845RKE
855-BROWN WIRE: (+ or -) DOME LIGHT
OUTPUT
(On-Board Relay):
Connect to dome light
activation circuit for Negative type circuits. For
Positive type circuits, open the control module and
switch jumper the plug as shown in illustration >>>.
RED WIRE: +12V POWER INPUT (15 amp fuse)
Connect to +12 Volt source with supplied fuse &
holder. Recommended location for this connection
is at the vehicle battery positive terminal.
WHITE WIRE: +12V FLASHING PARKING LIGHT
OUTPUT
Connect to switched parking light wire at back of light switch. If this is not possible, connect directly to one of the
parking lights at the front of the vehicle. European vehicles require separate right and left circuits. Use a dual relay or
2 diodes to separate the output signal.
Summary of Contents for CS-845.RKE.II
Page 12: ......
