OPERATION
IGNITION TRIGGER (OPTIONAL)
This optional feature allows the unit to activate the panic mode if an unauthorized operator turns on the Ignition after
the vehicle had been locked
using the remote
. This is similar to an alarm feature. To avoid an Ignition trigger, use the
remote for BOTH LOCKING and UNLOCKING the vehicle. If system does trigger, press button #4 to reset.
EMERGENCY OVERRIDE/VALET MODE (WITH OPTIONAL STARTER DISABLE FEATURE)
If you have lost the transmitter or it stops working for any reason and the system was locked with the remote
Emergency Disarm is needed to override the Starter Disable circuit. Open the door with the key, turn the ignition on
and press the override/program button for seconds you will get (1) short horn chirp and (1) light flash. This will also put
the system into VALET mode. If Optional LED light is installed, it will turn ON and stay on solid. (CS 845RKE II must
hold button for 10 seconds to reset)
VALET MODE
To get in and out of VALET mode, turn the ignition on and press the override/program button for about 2 seconds.
When going into VALET you will get (1) horn chirp, (1) light flash, and LED will be on SOLID. When coming out of
VALET mode you will get (2) Chirps, (2) Flashes, and LED will go out. Separate driver’s unlock and Starter Disable
features will not operate when in VALET mode. (CS-845 RKE II must hold button for 5 seconds for Valet mode.)
AUTOLOCK/UNLOCK WITH IGNITION
The doors will automatically lock when the ignition is turned on and will unlock when the ignition is turned off
.
If this is
not desired, See Programming Options to change this feature.
HORN CHIRP CONFIRMATION
This system can be programmed for short chirps of the Factory Car Horn along with the Flashing Parking lights for
LOCK/UNLOCK confirmation. If this is not desired, See Programming Options to change this feature.
DOME LIGHT ILLUMINATION (OPTIONAL)
This feature turns on the vehicles dome light upon disarm for 30 seconds or until the key is inserted and turned on.
This will provide illuminated entry to your vehicle at night or in dimly lit areas for safety and security.
ADDITIONAL INSTALLATION ACCESSORIES
CS-6600
DLM
CS-6500
DLI
Plug-in Door lock interface module for CS845/855RKE
Plug-in Door Lock pulse inverter for
installation into Reverse Polarity or Aftermarket Motor
CS-845RKE installation into vehicles
door
lock
systems. with
Positive
Door
lock
systems.
XX-402A
/
XX-402B
/
XX-402PB
XX-SRS
/
XX-DRS
External Relays for use with Power Trunk Release
Pre-wired plastic relay sockets for single or
Power Door Locks, Starter Disable etc.
dual relay installation
Summary of Contents for CS-845.RKE.II
Page 12: ......
