Page 12
The Crime Guard 250i6 vehicle security system is equipped with a built-in “shock”
sensor which detects impact to the vehicle. As vehicles differ structurally, and
mounting locations of the system control module vary, this shock sensor is easily
adjustable. The shock sensor adjustment is found on the rear of the control module
and siren assembly, below a weatherproofing rubber cover plug. Turning the
adjustment clockwise increases sensitivity, and turning the adjustment counter
clockwise decreases the sensor’s sensitivity. If adjustments are made to the
sensor, the rubber plug must always be replaced.
Shock Sensor & Prewarning
Bypassing the Auxiliary Sensor: If desired, the system may be armed, but
without the auxiliary sensor being part of the system’s protection. Upon arming,
immediately after the single arming confirmation chirp, simply press and release
the Transmitter’s Small Button; the system will chirp the siren once again to
confirm that the sensor is bypassed. When the sensor has been bypassed, it will
not activate the alarm, nor will it have the prewarning operation.
Prewarning Detection: The shock sensor circuit features “prewarning” operation.
When the security system detects a light impact through the sensor, it will respond
chirping three times, whereas a heavy or sharper impact will fully activate the
system, sounding the siren and flashing the parking lights, if these are connected.
Page 13
To Bypass Shock Sensor:
Press & Release the “Arm” Button THEN
Press & release
“button 3” (1 more
chirp is heard- the
shock
Press &
release
the “Arm”
button
(1 chirp is
FIRST
THEN
THE PARKING LIGHTS
WILL FLASH ONCE
UPON ARMING
FIRST: THE SIREN WILL CHIRP
SECOND: THE SIREN WILL
CHIRP
ONCE AGAIN INDICATING
Valet Mode & Emergency Override
As noted in the “Introduction” section of this booklet, the Valet/Override Switch is
not essential, but its inclusion offers several convenience benefits. The Valet/
Override Switch can perform two distinct functions: accessing Valet Mode and
performing an Emergency Override of an armed and activated system. It is
important that you know the location of the Valet Switch; a Valet Switch and LED
Status Indicator combination holder is provided with the Crime Guard 250i6 kit, and
may have been installed. If the Valet/Override Switch is used, the Status Indicator
Light’s use is also highly recommended, as it shows the presence of Valet Mode.
Summary of Contents for Crime Guard 250i6
Page 2: ......
